uart_async test and spi_loopback test require UART and SPI
with an ASYNC option.
The SAM0 UART/SPI driver requires configuring DMA support.
Arduino MKRZero is not DMA configured like other SAM0 boards.
We exclude it from the tests.
ea36f9b and f4c5bdf already exclude other SAM0 boards from these tests.
Arduino MKRZero also followed these PR policies.
Signed-off-by: TOKITA Hiroshi <tokita.hiroshi@fujitsu.com>
if DMA support is not present, LPUART driver will not compile when async
API support is required. Skip test cases when dma support is not present
and LPUART driver is enabled.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Some names of the test cases are duplicated within the project.
This commit contains the proposed names of the test scenarios.
Signed-off-by: Katarzyna Giadla <katarzyna.giadla@nordicsemi.no>
The SAM0 uart driver requires dma configured for async support and
the uart async support assumes all UARTs support async. None of the
atmel SAM0 boards are configured this way and thus the tests will
not currently build for these boards.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Added gpio_loopback to indicate that test requires pins to be
shorten. This allows to filter out tests on setup which does
not have pin setup.
Signed-off-by: Krzysztof Chruscinski <krzysztof.chruscinski@nordicsemi.no>
Add a build only test to validate correct compilation of the uart_rtt
driver. No harness that connects to RTT is defined, and therefore the
test can't be run by CI.
Signed-off-by: Jordan Yates <jordan.yates@data61.csiro.au>
The seasonal overhaul of test identifiers aligning the terms being used
and creating a structure. This is hopefully the last time we do this,
plan is to document the identifiers and enforce syntax.
The end-goal is to be able to generate a testsuite description from the
existing tests and sync it frequently with the testsuite in Testrail.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Added tests for async UART API and test configuration for
nrf52840_pca10056 board.
For tests to work, RX and TX pins have to be connected together
and second UART is needed to output results to console.
Signed-off-by: Mieszko Mierunski <mieszko.mierunski@nordicsemi.no>
