bartoszek/zephyr
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
f18f94ee18
zephyr/samples/drivers/misc/grove_display
History
Gerard Marull-Paretas c7b5b3c419 samples: migrate includes to contain <zephyr/...> prefix 
In order to bring consistency in-tree, migrate all samples to the use
the new prefix <zephyr/...>. Note that the conversion has been scripted:

```python
from pathlib import Path
import re

EXTENSIONS = ("c", "h", "cpp", "rst")

for p in Path(".").glob("samples/**/*"):
    if not p.is_file() or p.suffix and p.suffix[1:] not in EXTENSIONS:
        continue

    content = ""
    with open(p) as f:
        for line in f:
            m = re.match(r"^(.*)#include <(.*)>(.*)$", line)
            if (m and
                not m.group(2).startswith("zephyr/") and
                (Path(".") / "include" / "zephyr" / m.group(2)).exists()):
                content += (
                    m.group(1) +
                    "#include <zephyr/" + m.group(2) +">" +
                    m.group(3) + "\n"
                )
            else:
                content += line

    with open(p, "w") as f:
        f.write(content)
```

Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
2022-05-06 11:29:59 +02:00
..
boards drivers: serial: Update sam0 drivers to use pinctrl 2022-03-24 15:45:37 -07:00
src samples: migrate includes to contain <zephyr/...> prefix 2022-05-06 11:29:59 +02:00
CMakeLists.txt
prj.conf
README.rst
sample.yaml samples: drivers: misc: grove_display: filter by DT compat enabled 2022-02-22 11:58:33 -08:00

README.rst 

.. _grove-lcd-sample:

Grove LCD
#########

Overview
********

This sample displays an incrementing counter through the Grove LCD, with
changing backlight.

Requirements
************

To use this sample, the following hardware is required:

* A board with ADC support
* `Grove LCD module`_
* `Grove Base Shield`_ [Optional]

Wiring
******

You will need to connect the Grove LCD via the Grove shield onto a board that
supports Arduino shields.

On some boards you will need to use 2 pull-up resistors (10k Ohm) between the
SCL/SDA lines and 3.3V.

Take note that even though SDA and SCL are connected to a 3.3V power source, the
Grove LCD VDD line needs to be connected to the 5V power line, otherwise
characters will not be displayed on the LCD (3.3V is enough to power just the
backlight).


Building and Running
********************

This sample should work on any board that has I2C enabled and has an Arduino
shield interface. For example, it can be run on the FRDM K64F board as
described below:

.. zephyr-app-commands::
   :zephyr-app: samples/subsys/display/grove_display
   :board: frdm_k64f
   :goals: flash
   :compact:

.. _Grove Base Shield: http://wiki.seeedstudio.com/wiki/Grove_-_Base_Shield
.. _Grove LCD module: http://wiki.seeed.cc/Grove-LCD_RGB_Backlight/