zephyr/drivers
Ryan McClelland 9d345fc447 drivers: i3c: add support for setaasa initialization
Adds a new DTS prop for i3c devices as support for the CCC SETAASA
requires prior knowledge of the target if it supports it according
to i3c spec v1.1.1 section 5.19.3.23.

This will be used as an optimization for bus initialization.

Signed-off-by: Ryan McClelland <ryanmcclelland@meta.com>
2024-09-10 17:17:04 -04:00
..
adc espressif: clean up unused code 2024-09-09 13:55:39 -04:00
audio drivers: audio: Add the wm8904 driver 2024-08-29 15:53:26 +02:00
auxdisplay
bbram
bluetooth driver/bluetooth / cyw208xx: enable CYW20829_BT_FW_TX10DBM_POWER 2024-09-02 11:58:18 +02:00
cache Revert "drivers: cache: nrf: enable CACHE_NRF_PATCH_LINEADDR for nRF92" 2024-09-09 13:54:39 -04:00
can drivers: can: shell: use shell_fprintf_normal instead of shell_fprintf 2024-09-10 11:44:23 +02:00
charger charger: bq25180: Add threshold voltage for precharge 2024-09-05 17:01:05 -04:00
clock_control drivers: syscon: update syscon driver for MCXA156 2024-09-10 12:39:18 -04:00
console drivers: console: rtt_console: use Segger recommended write API 2024-08-12 10:14:34 +02:00
coredump
counter drivers: counter: nrfx_timer: Add barrier when reading CC 2024-09-03 14:40:10 +01:00
crypto
dac drivers: stm32: Select PINCTRL when required 2024-09-03 14:40:55 +01:00
dai drivers: dai: sai: don't crash on underrun/overrun 2024-08-27 10:50:53 -04:00
disk drivers: stm32: Select PINCTRL when required 2024-09-03 14:40:55 +01:00
display drivers: display: stm32_ltdc: fix return value 2024-09-10 11:43:48 +02:00
dma drivers: dma: Add initial SiM3U1xx support 2024-09-10 12:38:36 -04:00
dp
edac
eeprom drivers/eeprom/eeprom_simulator: Remove reference to native_posix 2024-08-16 09:20:58 +01:00
entropy entropy: native_posix: Add kconfig to not seed by default 2024-09-05 16:56:33 -04:00
espi drivers/espi: it8xxx2: Fix mask when SRAM size not the power of 2 2024-09-02 11:49:52 +02:00
ethernet drivers: ethernet: dwc_xgmac: Added dwc-xgmac 2024-09-05 17:03:05 -04:00
firmware firmware: scmi: add support for pinctrl protocol 2024-08-19 10:05:16 -04:00
flash drivers: flash: support flash driver for MCXA156 2024-09-10 12:39:18 -04:00
fpga drivers: fpga: add driver for renesas slg471X5 2024-08-26 17:06:14 +02:00
fuel_gauge fuel_gauge: composite analog fuel gauge 2024-08-29 16:12:36 -04:00
gnss gnss: rename u-blox M10 driver to M8 2024-08-26 17:27:12 -04:00
gpio drivers: gpio_mcux: update gpio_mcux driver for MCXA156 2024-09-10 12:39:18 -04:00
haptics drivers: haptics: drv2605: Hard codes open loop mode for LRA mode 2024-08-20 14:52:32 -04:00
hwinfo drivers: hwinfo: litex: depend on devicetree 2024-08-29 16:10:57 -04:00
hwspinlock style: drivers: comply with MISRA C:2012 Rule 15.6 2024-08-20 10:33:51 +02:00
i2c espressif: clean up unused code 2024-09-09 13:55:39 -04:00
i2s drivers: i2s: Do not ignore the return value from queue_put. 2024-09-05 09:50:08 +02:00
i3c drivers: i3c: add support for setaasa initialization 2024-09-10 17:17:04 -04:00
ieee802154
input drivers: input: input_gt911: fix OOB buffer write to touch points array 2024-09-06 10:13:14 -05:00
interrupt_controller arm/gicv3: set routing affinity before enable IRQ 2024-09-04 09:53:04 +02:00
ipm drivers: esp32: Interrupts flags configuration 2024-08-22 14:25:25 -04:00
kscan
led drivers: led: lp5562: reuse engine already linked 2024-09-04 21:27:53 +02:00
led_strip drivers: ws2812_gpio: Make timing configurable and less hardware dependend 2024-09-06 11:31:00 -04:00
lora lora: driver: sx12xx: fix driver recv func when RX error occurs 2024-08-05 18:37:11 -04:00
mbox drivers: mbox: Fix error code in Nordic's implementation 2024-09-04 12:52:24 +02:00
mdio drivers: ethernet: dwc_xgmac: Added dwc-xgmac 2024-09-05 17:03:05 -04:00
memc drivers: stm32: Select PINCTRL when required 2024-09-03 14:40:55 +01:00
mfd
mipi_dbi mipi_dbi: stm32: use proper type for timeout argument 2024-08-27 12:45:48 +02:00
mipi_dsi
misc drivers: misc: coresight: nrf_etr: Add standalone mode 2024-09-06 11:31:27 -04:00
mm mm: common: reset mappings during simple mapping failures 2024-08-28 16:35:43 -04:00
modem lib: net_buf: rename header file from zephyr/net/buf.h to zephyr/net_buf.h 2024-09-07 11:19:05 -05:00
mspi drivers: update AMBIQ drivers to use proper base address 2024-08-11 19:18:09 -05:00
net lib: net_buf: rename header file from zephyr/net/buf.h to zephyr/net_buf.h 2024-09-07 11:19:05 -05:00
pcie
peci
pinctrl drivers: stm32: Make some config symbols menuconfig symbols 2024-09-05 16:58:04 -04:00
pm_cpu_ops
power_domain
ps2 style: drivers: comply with MISRA C:2012 Rule 15.6 2024-08-20 10:33:51 +02:00
ptp_clock
pwm espressif: clean up unused code 2024-09-09 13:55:39 -04:00
regulator espressif: clean up unused code 2024-09-09 13:55:39 -04:00
reset
retained_mem drivers: retained_mem: nrf: implement using nrfx_ram_ctrl helper 2024-08-14 12:35:17 -04:00
rtc drivers: rtc: Add RTC driver for Infineon XMC4xxx devices 2024-09-04 09:54:52 +02:00
sdhc drivers: esp32: Interrupts flags configuration 2024-08-22 14:25:25 -04:00
sensor sensor: bme680: only read compensation params once 2024-09-10 11:44:30 +02:00
serial drivers: serial: ambiq uart update 2024-09-09 18:40:46 -04:00
sip_svc
smbus drivers: stm32: Make some config symbols menuconfig symbols 2024-09-05 16:58:04 -04:00
spi drivers: spi: spi_max32: Add DMA support 2024-09-10 14:39:51 +01:00
stepper drivers: stepper: refactor gpio stepper driver 2024-09-03 10:42:19 +02:00
syscon
tee
timer drivers: timer: nrf_grtc: Add GRTC fix for app and rad cores 2024-09-06 11:29:06 -04:00
usb drivers: udc: mcux: move isr context codes to work context 2024-09-10 12:38:03 -04:00
usb_c drivers: stm32: Select PINCTRL when required 2024-09-03 14:40:55 +01:00
video drivers: video: esp32s3: add support for cam interface 2024-09-06 11:26:59 -04:00
virtualization
w1
watchdog espressif: clean up unused code 2024-09-09 13:55:39 -04:00
wifi drivers: wifi: nxp: add Kconfig to enable Wi-Fi features 2024-09-10 11:44:03 +02:00
xen style: drivers: comply with MISRA C:2012 Rule 15.6 2024-08-20 10:33:51 +02:00
CMakeLists.txt stepper motor controller: introduce api 2024-08-27 12:43:39 +02:00
Kconfig stepper motor controller: introduce api 2024-08-27 12:43:39 +02:00