SETUP data is unconditionally ACKed by the controller. Other DATA
packets sent to OUT control endpoint 0 (i.e. OUT Data Stage packets
and OUT Status Stage packet) are ACKed by the device only if the
endpoint was enabled with CNAK bit set.
In Buffer DMA mode controller will lock up in following scenario:
* OUT EP0 is not enabled, e.g. OUT Status Stage has finished
* Host starts Control Write transfer, i.e. sends SETUP DATA0 and
device ACKs (regardless if endpoint is enabled or not)
* host sends OUT Data Stage (OUT DATA1)
- software enables endpoint to be able to receive next SETUP data
while host is transmitting the OUT token. If CNAK bit is set
alongside the EPENA bit, the device will ACK the OUT Data Stage.
If CNAK bit is not set, the device will NAK the OUT Data Stage.
When the lockup occurs, from host perspective the OUT Data Stage packet
was successfully transmitted. This can result in host starting IN Status
Stage if there was only one OUT Data Stage packet. This in turn results
in device never getting the DOEPTINT0 SetUp interrupt. Besides just not
getting the SetUp interrupt, any subsequent control transfer won't be
noticed by device at all.
The lockup was first observed while stress testing. The host was issuing
endless sequence of Control Write, Control Read, Control Write, Control
Read, ... commands. When the controller did lock up in Buffer DMA mode,
from host perspective the device was timing out all control transfers.
Avoid the Buffer DMA lockup by setting CNAK bit only when necessary.
Signed-off-by: Tomasz Moń <tomasz.mon@nordicsemi.no>
6e3f8d4967