zephyr

History

Kumar Gala 5d36157c7c sensors: Remove unnecessary Kconfig setting of sensors Sensor Kconfig sybmols should be enabled if CONFIG_SENSOR=y and the devicetree node for the sensor is enabled. We can remove explicitly enabling specific sensor drivers in .conf files. Signed-off-by: Kumar Gala <galak@kernel.org>		2022-07-25 15:18:56 +02:00
..
src	drivers: sensor: bq274xx: Convert sample to use DEVICE_DT_GET_ONE	2022-06-17 08:52:44 -05:00
CMakeLists.txt
prj.conf	sensors: Remove unnecessary Kconfig setting of sensors	2022-07-25 15:18:56 +02:00
README.rst
sample.yaml

README.rst

.. _bq274xx-sample:

BQ274XX Sensor Sample
#####################

Overview
********

This sample application retrieves all the fuel gauge parameters,
- Voltage, in volts
- Average current, in amps
- Standby current, in amps
- Maximum load current, in amps
- Gauge temperature
- State of charge measurement in percentage
- Full Charge Capacity in mAh
- Remaining Charge Capacity in mAh
- Nominal Available Capacity in mAh
- Full Available Capacity in mAh
- Average power in mW
- State of health measurement in percentage

from BQ274XX sensor and prints this information to the UART console.

Requirements
************

- nrf9160_innblue22 board with BQ274XX sensor `BQ274XX Sensor`_

Building and Running
********************

Build this sample using the following commands:

.. zephyr-app-commands::
   :zephyr-app: samples/sensor/bq274xx
   :board: nrf9160_innblue22
   :goals: build flash

References
**********

.. target-notes::

.. _BQ274XX Sensor: http://www.ti.com/lit/ds/symlink/bq27421-g1.pdf