In order to bring consistency in-tree, migrate all subsystems code to
the new prefix <zephyr/...>. Note that the conversion has been scripted,
refer to zephyrproject-rtos#45388 for more details.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Commit f7c4fe6778 ("shell: optimize history storage a bit") forgot
to distinguish between the newly allocated history item and the previous
one, causing havoc on ring buffer wraparounds with excess padding.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
When padding is added to "fill" the gap in order to wrap to the
beginning of the ring buffer, such padding is attributed to the
current item being added. Let's attribute it to the previous entry
instead so it'll be freed along with that entry and make the space
available one entry sooner, increasing the chances for keeping the
current entry around longer.
If ring buffer is empty then always reset it up front to get best
alignment right away i.e. beginning of buffer.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
Make it possible to "finish" with fewer bytes than what was "claimed".
This was possible before on the get side, but the put side was
cummulative wrt finish. The revamp made it cummulative on both sides.
Turns out that existing users rely on the opposite behavior which is
more logical and useful. So make both sides that way.
Adjust documentation, test case and users accordingly.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
No ring_buf_get_finish() should be performed on ring_buf memory that
wasn't claimed beforehand. Using ring_buf_get() with a NULL destination
does both the claim and the finish part without retrieving anything.
This is especially important with the ring_buffer revanp where the above
is enforced for proper operation.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
Shell history module reworked to use ring buffer for storing
commands. Dedicated buffer is used to story all command lineary.
History capacity is in bytes not in number of entries, e.g.
many short commands can be stored or few long (depending on
CONFIG_SHELL_HISTORY_BUFFER).
Removed implicit command null termination from shell_history and
added it to shell after fetching command line from the history.
Signed-off-by: Krzysztof Chruscinski <krzysztof.chruscinski@nordicsemi.no>
This patch increases the amount of slab memory per item for the shell
history to match the maximum command input buffer size plus the
accounting information for the dnode list item.
Signed-off-by: Andy Gross <andy.gross@linaro.org>
Change arg_len to be u16_t in shell_history_get since it is returning
a value that can be hold by u16_t.
Signed-off-by: Flavio Ceolin <flavio.ceolin@intel.com>
When user was typing a new command and next pressed an up arrow
shell has displayed previously executed command. Next it was not
possible to display back currently edited command using a down arrow.
Fixes#10766.
Signed-off-by: Jakub Rzeszutko <jakub.rzeszutko@nordicsemi.no>
