Add ESPI SAF features to the Microchip eSPI driver as
a separate file. ESPI SAF depends upon the core eSPI
driver adding the ability to attach the system SPI
flash to the EC eSPI endpoint instead of the host
eSPI controller.
Signed-off-by: Scott Worley <scott.worley@microchip.com>
This enables the ACPI_EC1 interface which is typically accessed
through ports 0x6A0 and 0x6A4 in Bios.
Signed-off-by: Rajavardhan Gundi <rajavardhan.gundi@intel.com>
Enable ESPI OOB channel by default in XEC driver.
Enable OOB channel transmit interrupt and handle OOB up/down correctly.
Change interrupt clearing, clear low level interrupt bits in subhandlers
and high level interrupt in aggregate handlers at the end.
Signed-off-by: Jose Alberto Meza <jose.a.meza.arellano@intel.com>
Use this short header style in all Kconfig files:
# <description>
# <copyright>
# <license>
...
Also change all <description>s from
# Kconfig[.extension] - Foo-related options
to just
# Foo-related options
It's clear enough that it's about Kconfig.
The <description> cleanup was done with this command, along with some
manual cleanup (big letter at the start, etc.)
git ls-files '*Kconfig*' | \
xargs sed -i -E '1 s/#\s*Kconfig[\w.-]*\s*-\s*/# /'
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Defining a symbol with 'menuconfig' just tells the menuconfig to display
any dependent symbols that immediately follow it in a separate menu.
'menuconfig' has no effect on symbol values.
Making a symbol that doesn't have any dependent symbols after it a
'menuconfig' should be avoided, because then you end up with an empty
menu, which is shown as e.g.
[*] Enable foo ---
This is how it would be shown if there were children but they all
happened to be invisible as well.
With a regular 'config', it turns into
[*] Enable foo
Change all pointless 'menuconfig's to 'config's.
See the section on 'menuconfig' on the Kconfig - Tips and Best Practices
page as well.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
When a eSPI slave needs to send back-to-back packets
updating status signal need to guarantee both status
reach the eSPI host, i.e. SCI=0 followed by SCI=1.
This change guarantees both packets are transmitted
over esSPI bus.
Allow to map eSPI host logical UART to a soc UART.
Signed-off-by: Jose Alberto Meza <jose.a.meza.arellano@intel.com>
The ESPI_PERIPHERAL_* symbols are surrounded by an
'if ESPI_PERIPHERAL_CHANNEL' in the same file, so no
need to put 'depends on ESPI_PERIPHERAL' on them.
'if' is just a shorthand for 'depends on'.
Also remove a redundant 'if ESPI' from ESPI_XEC.
drivers/espi/Kconfig.xec is sourced within an 'if ESPI' in
drivers/espi/Kconfig.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Add eSPI Microchip XEC driver
Include support for peripheral & virtual wires (channel 0-1)
OOB and flash support can be added in the future
Fix compilation error in pinmux driver
Signed-off-by: Jose Alberto Meza <jose.a.meza.arellano@intel.com>
