The test needs to cram at least 8 messages into the log buffer, but
with 64-bit pointers only 5 fit, so make the buffer a bit bigger.
Signed-off-by: Charles E. Youse <charles.youse@intel.com>
We don't allow an ifdef in ztest_test_suite because its a macro. We
usually handle this by defining multiple blocks and ifdef around them.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Fatal error reporting now only dumps to the log mechanism,
so enable it in immediate mode for all tests to ensure
that fatal errors are visible and no messages are lost.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
Switch form using privater FCB error codes to
errno codes. FCB private codes convention were compatible
with <errno.h> codes:
- 0 mean success
- negative values mean errors
- similar error types.
There was no sense to kept private FCB error codes.
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
Extended case for testing deletion of the first entry while
it is the most recent one.
This extension allow to reproduce issue #18813 and shows that
the bugfix works well.
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
Make sure that the last entry added is deleted correctly by storing the
fact that one was found in a local variable.
Fix by Laczen JMS <laczenjms@gmail.com>
Fixes#18813.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
The test assumes that storage is clear before it runs. This
might be not true as lot of devices are only partially erased by
'west flash'.
Patch introduce procedure for testing whether test runs the first
time and clear storage if so.
The procedure uses mark which is stored inside SoC embedded program
flash. It will not work one devices on which read/write to it is
impossible.
fixes#16463
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
Add test for check whether deleted entry is recognized properly
after settings reload.
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
Closes#18392 by asserting and returning an error if the block size is
not positive.
Closes#18458. The diagnosis here was not relevant as an in-range EOS
is written before the buffer is used, but using the non-terminated
length is slightly more clear about intent and may avoid a read overrun
of the mount point.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
This emulates a RISC-V in 64-bit mode on a SiFive FE310 dev board.
Memory is tight so a few tests had to be disabled due to the extra
memory usage compared to qemu_riscv32.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
Added tests of flash driver compatibility with fcb-backend.
For flash drivers which support write-block-size bigger than 1 B
test of unaligned data access uses native write-block-size
as it is dedicated to check whether settings works well on platform
which has 1 B access which is native on the current DUT.
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
Added test for check behavior on deleting existent entry,
nonexistent entry and already deleted entry.
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
Added test for check wheter initialization works well when nvs
storage is full filled. Test also check weheter can delet any
entry from full filled NVS.
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
There's desire to be able to customize parameters on a per-filesystem
basis, which means we need a way to override the Kconfig defaults which
are global. This also means the littlefs data structure cannot own the
cache and lookahead buffers.
Switch to using a macro to define the littlefs data structure. The
default version uses the Kconfig constants. A custom one takes
arguments providing the most likely partition-specific parameters.
Finally the user is free to bypass the helper macros and set any
parameters desired, though validation is limited and only present when
CONFIG_DEBUG is enabled.
Extend the test suite with a performance module, which confirms that
these settings have an impact proportional to the log of changes to the
cache or IO sizes.
Signed-off-by: Peter A. Bigot <pab@pabigot.com>
Existing file system implementations do not provide the special "."
(current) and ".." (parent) directory entries in the readdir results.
littlefs does.
Remove these entries in the abstraction layer. This simplifies code in
higher level consumers that aren't prepared to see them. Consumers like
FUSE that need them can put them back without having to worry about
conflicts.
Closes issue #17951
Signed-off-by: Peter A. Bigot <pab@pabigot.com>
This board and SoC was discontinued some time ago and is currently not
maintained in the zephyr tree.
Remove all associated configurations and variants from the tree.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
The test assumes that the settings area is empty. This happens
naturally when the area is in the SOC flash and the chip flash is
entirely erased when the test is programmed. The test will fail if the
programmed board is reset and the test run again.
The test cannot pass by reprogramming when the storage area is in an
external flash device.
Make things repeatable for FCB by erasing the storage partition before
running the test.
Signed-off-by: Peter A. Bigot <pab@pabigot.com>
This reverts commit 755cc644cc.
This approach is problematic in several ways. First, `intptr_t` could
cause undefined behavior in the subtraction when the pointer converts to
a negative value. Except in weird cases where the sign of the pointer
identifies a memory domain (like kernel vs userspace) I'm unaware of any
valid use of `intptr_t`.
Second, this macro was created to address a special need that cannot
rely on defined behavior: i.e. to ensure that data definitions are
placed in contiguous space and access is provided through linker-defined
symbols, for which the language required alignment and continuity is not
guaranteed.
A macro that calculates the span between linker symbols has very
different semantics than one that calculates the difference between
pointers. Replace the global PTR_DIFF with a documented local macro
that tests what's necessary without risking integer overflow.
Signed-off-by: Peter A. Bigot <pab@pabigot.com>
Let's use the PTR_DIFF() helper which performs pointer difference in a
64-bit compatible way, and use %zu for printing sizeof() results.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
The size_t type is either compatible with an int on 32-bit target, or
a long on 64-bit targets. It could even be a long even on some 32-bit
targets. Let's use the z qualifier in the printf format to be compatible
with whatever flavor in use.
In case of pointers, let's just use %p with pointers directly and
avoid casts altogether.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
This fixes the following error:
passing argument 5 of ‘fsutil_read_file’ from incompatible pointer type
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
Forced attempt to set the device address is unpredictable
and also should not be done during testing.
Signed-off-by: Johann Fischer <j.fischer@phytec.de>
CONFIG_TEST_HW_STACK_PROTECTION is set by default in tests,
and that one selects HW_STACK_PROTECTION option. Therefore,
we do not need to set that one explicitly in the test project
configuration files. We clean up some redundant occurrences of
CONFIG_HW_STACK_PROTECTION=y from the tree.
Signed-off-by: Ioannis Glaropoulos <Ioannis.Glaropoulos@nordicsemi.no>
move misc/reboot.h to power/reboot.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move misc/printk.h to sys/printk.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move misc/byteorder.h to sys/byteorder.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move misc/__assert.h to sys/__assert.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move flash.h to drivers/flash.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move can.h to drivers/can.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move zephyr/jwt.h to data/jwt.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move json.h to data/json.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move disk_access.h to disk/disk_access.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move stats.h to stats/stats.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move nvs/nvs.h to fs/nvs.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move fcb.h to fs/fcb.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move fs.h to fs/fs.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
move flash_map.h to storage/flash_map.h and
create a shim for backward-compatibility.
No functional changes to the headers.
A warning in the shim can be controlled with CONFIG_COMPAT_INCLUDES.
Related to #16539
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
USBD_CFG_DATA_DEFINE macro has not consider that a class
could have more than one set of usb_cfg_data struct.
If a class has more than one set of usb_cfg_data
then they should be sorted the same way like by
USBD_DEVICE_DESCR_DEFINE macro.
Fixes: #16240
Signed-off-by: Johann Fischer <j.fischer@phytec.de>
