As the test suite is intended to run over loopback interfce, use
loopback address and skip configuration of other addresses.
Signed-off-by: Robert Lubos <robert.lubos@nordicsemi.no>
It can happen that two similar stacks enter a retransmission cycle
due to a packet collision. If the transmission timeout is the same
both stacks will retry at the same moment resulting in another
collision.
By introducing a randomized retry timeout, the chance of
a second collision is reduced and it reduces furter the more
retransmissions occur.
Signed-off-by: Sjors Hettinga <s.a.hettinga@gmail.com>
Fixes: #38403
Adding NET_DRIVERS menuconfig so that network drivers are grouped
together in its own menu entry under drivers, similar to most other
drivers.
This further has the advantages that `CONFIG_NET_DRIVERS` can be used
for testing to determine if network drivers has been selected.
This changed revealed a dependency loop where both `select` (for SLIP)
and `depends` (for PPP) which both depends on NET_DRIVERS` where in use
in the dependency tree for Qemu networking, especially NET_SLIP_TAP.
This is handled by defaulting `NET_DRIVERS` to `y` when building for a
Qemu target.
`SLIP` had a dependency to `!QEMU_TARGET || NET_QEMU_SLIP`. This is
changed so that SLIP prompt depends on `!QEMU_TARGET` which provides
full user control in hardware but makes the symbol promptless on Qemu
targets.
Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>
Unit test code requires IPv6 to be ready. Select
CONFIG_NET_CONFIG_NEED_IPV6=y to ensure that.
Signed-off-by: Marcin Niestroj <m.niestroj@grinn-global.com>
Unlike CONFIG_HW_STACK_PROTECTION, which greatly helps
expose stack overflows in test code, activating
userspace without putting threads in user mode is of
very limited value.
Now CONFIG_TEST_USERSPACE is off by default. Any test
which puts threads in user mode will need to set
CONFIG_TEST_USERSPACE.
This should greatly increase sanitycheck build times
as there is non-trivial build time overhead to
enabling this feature. This also allows some tests
which failed the build on RAM-constrained platforms
to compile properly.
tests/drivers/build_all is a special case; it doesn't
put threads in user mode, but we want to ensure all
the syscall handlers compile properly.
Fixes: #15103 (and probably others)
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
As written originally, the tests assumed that if k_uptime_get_32()
returns times in milliseconds, that it also has millisecond
resolution. That however doesn't have to be the case, and indeed,
default timer interrupt period used by Zephyr is 10ms, and so system
time is incremented in such units. So, instead of "<= 1" tests to
account for timing increment, use "<= FUZZ".
For blocking tests, increase the timeout from previously used 10ms,
so we can reliably tests delays under the conditions described.
Also, enable CONFIG_QEMU_TICKLESS_WORKAROUND. Most other
timing-related tests have this enabled, and it may affect
stability of QEMU testing too.
Fixes: #12994
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
