Generic node_rx_hdr struct contains data not used for done event, so this
pdu specific data is moved to node_rx_pdu to minimize memory usage for
MFIFO_done alloc.
This however calls for a considerable write-through replacing the generic
node_rx_hdr with node_rx_pdu when relevant and needed.
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
For asymetrical features there needs to be a separate mechanism to
unmask features in peer. This must be used in central for unmasking in case
of 'unsupported in peer' condition for CIS Create.
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
If a CIS create is requested prior to having a complete feature exchange
the central will initiate a feat exch before enqueing the CIS create.
IF then the feature exchange results in peripheral NOT supporting
CIS create the central needs to allocate an RX node for the NTF
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
- Fix masking for no coded phy
- Allow ISO_Interval < SDU_Interval for framed mode
- Change BT_HCI_ERR_INSUFFICIENT_RESOURCES to
BT_HCI_ERR_CONN_LIMIT_EXCEEDED.
- Prevent starting same CIS twice
- Cancel an initiated CIS creation procedure if terminated before
sending CIS_IND.
- Implement canceling of local CC procedure. Respond to CIS_RSP with
REJECT, if canceled after CIS_REQ was sent.
- Introduce state CIG_STATE_INITIATING for central, to keep track of
initiating CIS connection, in transition between CONFIGURABLE and
ACTIVE.
Fixes EBQ test /HCI/CIS/BC-03-C.
Signed-off-by: Morten Priess <mtpr@oticon.com>
First implementation had a math error where the offset would be the
remainder from division (modulo). It should have been an ISO interval
minus the remainder. Refactored to not use modulo.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Rework internal header files to not have includes, rather
have the required includes in the c source files.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
In order to have clean, self-contained HCI headers that do not have any
dependencies towards the Host or any other part of the system (except
types), reorganize the headers in the following way:
- Split out the macros and structs from hci.h to a new hci_types.h
- Merge the existing hci_err.h into the new hci_types.h
Fixes#58214.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Instead of using the node ref used for TX ack for storing a TX node
pre-allocated in case of NTF RX node availability delay, introduce a
separate store to TX node. This to avoid misunderstanding on clean-up
in terminate flow.
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
When possible re-use the already allocated RX node for notifications.
Store (retain) RX node and Link element on RX if NTF could occur.
Pass link element to LLCP (ull_cp_rx()) together with RX node.
New RX node type RETAIN introduced to signal retention
When no RX node is available allocate one and hold off TX on procedures
until such time that a node is available for NTF.
In case waiting for NTF buffer avail is needed, allocate and store TX
node to use for TX once NTF becomes available.
CIS Established (incl. timeout handling) is now handled entirely as a
specific event driven by ull_conn_iso - ie removal of procedure check
of cis->established and cis->expire, as this is doubling mechanism
in the conn_iso context.
Unit test and helpers updated to handle new node type.
Function ull_cp_release_ntf() was used only in unit test, so moved to
helper context.
Updating release_ntf to handle the fact that with piggy-backing in test
context the node used for NTF can be from two different memory pools
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
BT Core Spec states that feature exchange should be initiated if
not already performed. So in this case initiate feature exchange
and 'abort' enqueued CIS create if peer doesn't support CIS peripheral
feature
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Central multiple CIS create implementation using advanced
scheduling to find the active CIG events and calculate the
CIS offset to be used in the LL_CIS_REQ PDU.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Implementation of preliminary Central with multiple CIS
create support in Lower Link Layer. Uses a simple CIS
offset calculation that works when ACL are created with
connection interval that is multiple of CIG ISO interval.
Each ACLs are offset using BT_CTLR_CENTRAL_SPACING hence
having the same CIG sync delay values for all the ACLs.
Advanced Scheduling to setup CIS in any order of ACL and
CIS combination, ACL placed anywhere in timeline and CIS
creation will come therein will be implemented in later
Pull Requests.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Include ticker expire remainder value when calculating the
cis_offset to acheive fine timing in scheduling the CIG
radio events relative to its associated ACL radio events.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
When possible re-use the already allocated RX node for notifications.
Store (retain) RX node and Link element on RX if NTF could occur.
Pass link element to LLCP (ull_cp_rx()) together with RX node.
New RX node type RETAIN introduced to signal retention
When no RX node is available allocate one and hold off TX on procedures
until such time that a node is available for NTF.
In case waiting for NTF buffer avail is needed, allocate and store TX
node to use for TX once NTF becomes available.
CIS Established (incl. timeout handling) is now handled entirely as a
specific event driven by ull_conn_iso - ie removal of procedure check
of cis->established and cis->expire, as this is doubling mechanism
in the conn_iso context.
Unit test and helpers updated to handle new node type.
Function ull_cp_release_ntf() was used only in unit test, so moved to
helper context.
Updating release_ntf to handle the fact that with piggy-backing in test
context the node used for NTF can be from two different memory pools
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
If CIS offset in LL_CIS_IND is less than EVENT_OVERHEAD_START_US, the
controller is not able to establish the CIS in the ACL connection event
specified, but needs to start setup one connection event earlier.
With this commit, if offset is larger than EVENT_OVERHEAD_START_US the
first CIS event can be prepared in due time immediately.
This enables the controller to setup first CIS, even when instant is
equal to the ACL event_counter.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Use instant_latency at the CIG start event count to detect
skipped connection event around the instant. In the future
add implementation to compensate for skipped ACL connection
event and adjust the CIS event count at CIG start.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Reuse ull_conn_event_counter() function in LLCP
implementation to get the current radio event counter value.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix CIG offset such that it follows after the ACL connection
time reservation to avoid overlapping.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Make Data, ISO, BIS and CIS PDU structure's octet 3 vendor
specific.
This will allow vendors not supporting the octet 3 or
CTEInfo (8 bits) to save 1 octet in their PDU structures.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
New LLCP will process the CIS establishement in the TX path, meaning it
will only process once every ACL connection interval.
If ACL connection interval is significantly longer than the ISO
interval, CIS packets corresponding to the ACL connection interval will
be lost. This may cause latency in audio rendition.
By processing the CIS establishment in the RX path, notification will be
sent immediately, and audio path is enabled fast to reduce latency.
When a CIS fails to establish, the controller shall complete the
procedure by sending a CIS_ESTABLISHED event containing the error.
Signed-off-by: Morten Priess <mtpr@oticon.com>
When the 'instant' of a CIS is postponed by increasing the conn_event of
the CIS_RSP compared to CIS_REQ, the CIS offset shall be calculated as
an equivalent window offset by an integer number of ISO intervals.
This is obtained by increasing the CIS_Offset_Min and CIS_Offset_Max by
the modulus of the connection interval delay time.
Signed-off-by: Morten Priess <mtpr@oticon.com>
To be able to timely start the first CIS/CIG, if the requested instant
is the next connection event, call ull_peripheral_iso_start directly
from rp_cc_state_wait_rx_cis_ind instead of waiting for next time
through the state machine.
To enable ULL/LLL to prevent adding latency when LLCP is waiting for
instant, local- and remote procedures with instant now expose a function
for checking this state.
Fixed event_counter function to prevent one-off in RX path. Unified to
use single function ull_conn_event_counter.
Fixed LLCP unit tests and added new mock function.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Do not assert on invalid PDU in CIS create procedure. Instead terminate
with reason BT_HCI_ERR_LMP_PDU_NOT_ALLOWED
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Adding a bit-mask to the 'extra' data structure allowing passing info
re. active CIS's to the ull_conn_iso_done handling. Per CIS storing
an expiration time counter, monitoring in done handling. Adding
establishment timeout monitor in CIS Create procedure, completing
and ntf'ing accordingly.
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Missing decode of conn_event_count on CIS_IND
Peripheral Suggest update to conn_event_count in case of a delayed
CIS_IND, allowing CIS peripheral more time to setup
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
The `bluetooth/common/log.h` and `bluetooth/common/log.c` files have been
removed. Files that were using them have been updated to use
`zephyr/logging/log.h` instead.
Those replacement have been done consequently:
- `/BT_DBG/LOG_DBG/`
- `/BT_ERR/LOG_ERR/`
- `/BT_WARN/LOG_WRN/`
- `/BT_INFO/LOG_INF/`
- `/BT_HEXDUMP_DBG/LOG_HEXDUMP_DBG/`
- `/BT_DBG_OBJ_ID/LOG_DBG_OBJ_ID/`
Also, some files were relying on the `common/log.h` include to include
`zephyr/bluetooth/hci.h`, in those cases the include of `hci.h` has
been added.
For files that were including `common/log.h` but not using any logs,
the include has been removed and not replaced.
Signed-off-by: Théo Battrel <theo.battrel@nordicsemi.no>
Move ull_peripheral_iso_start ull_peripheral_iso_ticker_cb to
ull_conn_iso, to share code between CIS peripheral and central.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Local procedure for CIS central establishment. Calls yet unimplemented
functions in ull_central. Changes are guarded by
CONFIG_BT_CTLR_CENTRAL_ISO.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Check LE event mask state as well as host controlled feature mask state
and reject CIS request accordingly.
Release pre-allocated ISO resources on rejection of request
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Setting the new LLCP as default exposed errors in CI tests, which
are fixed here
Note that advanced scheduling needs to be disabled. Work is in
progress for implementing this for the new LLCP
Signed-off-by: Andries Kruithof <andries.kruithof@nordicsemi.no>
Any project with Kconfig option CONFIG_LEGACY_INCLUDE_PATH set to n
couldn't be built because some files were missing zephyr/ prefix in
includes
Re-run the migrate_includes.py script to fix all legacy include paths
Signed-off-by: Tomislav Milkovic <milkovic@byte-lab.com>
Implements PDU flow and unittest of CIS Create on Peripheral
Hooks CIS Create into the controller and fixes a few minor
things in ull to allow for running with NEW LLCP
Also handles CONFIG based comilation of CIS Create
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
