From 0d2cf4f77ea87655519413bc57c709ea52dfeb0c Mon Sep 17 00:00:00 2001 From: Andrej Butok Date: Wed, 14 May 2025 09:55:37 +0200 Subject: [PATCH] boards: nxp: mimxrt1064_evk: doc: fix user guide link. - Fixes link to the MIMXRT1064-EVK User Guide (was broken). - Adds a note about SW7 and SW5 settings to boot from QSPI. Signed-off-by: Andrej Butok --- boards/nxp/mimxrt1064_evk/doc/index.rst | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) diff --git a/boards/nxp/mimxrt1064_evk/doc/index.rst b/boards/nxp/mimxrt1064_evk/doc/index.rst index 6e5f6c3971d..0c828258dba 100644 --- a/boards/nxp/mimxrt1064_evk/doc/index.rst +++ b/boards/nxp/mimxrt1064_evk/doc/index.rst @@ -275,9 +275,10 @@ Configuring a Debug Probe ========================= .. note:: - When the device transitions into low power states, the debugger may be - unable to access the chip. Use caution when enabling ``CONFIG_PM``, and - if the debugger cannot flash the part, see :ref:`Troubleshooting RT1064` + * To boot from the QSPI flash, make sure SW7 is set to 0010 and SW5 is set to 0000. + * When the device transitions into low power states, the debugger may be + unable to access the chip. Use caution when enabling ``CONFIG_PM``, and + if the debugger cannot flash the part, see :ref:`Troubleshooting RT1064` For the RT1064, J47/J48 are the SWD isolation jumpers, J42 is the DFU mode jumper, and J21 is the 20 pin JTAG/SWD header. @@ -396,7 +397,7 @@ connected to the EVK properly. https://www.nxp.com/webapp/Download?colCode=IMXRT1064QSG .. _MIMXRT1064-EVK User Guide: - https://www.nxp.com/docs/en/data-sheet/MIMXRT10601064EKBHUG.pdf + https://www.nxp.com/webapp/Download?colCode=MIMXRT10601064EKBHUG .. _MIMXRT1064-EVK Debug Firmware: https://www.nxp.com/docs/en/application-note/AN13206.pdf