diff --git a/boards/nxp/mimxrt1064_evk/doc/index.rst b/boards/nxp/mimxrt1064_evk/doc/index.rst
index 6e5f6c3971d..0c828258dba 100644
--- a/boards/nxp/mimxrt1064_evk/doc/index.rst
+++ b/boards/nxp/mimxrt1064_evk/doc/index.rst
@@ -275,9 +275,10 @@ Configuring a Debug Probe
 =========================
 
 .. note::
-	When the device transitions into low power states, the debugger may be
-	unable to access the chip. Use caution when enabling ``CONFIG_PM``, and
-	if the debugger cannot flash the part, see :ref:`Troubleshooting RT1064`
+	* To boot from the QSPI flash, make sure SW7 is set to 0010 and SW5 is set to 0000.
+	* When the device transitions into low power states, the debugger may be
+	  unable to access the chip. Use caution when enabling ``CONFIG_PM``, and
+	  if the debugger cannot flash the part, see :ref:`Troubleshooting RT1064`
 
 For the RT1064, J47/J48 are the SWD isolation jumpers, J42 is the DFU
 mode jumper, and J21 is the 20 pin JTAG/SWD header.
@@ -396,7 +397,7 @@ connected to the EVK properly.
    https://www.nxp.com/webapp/Download?colCode=IMXRT1064QSG
 
 .. _MIMXRT1064-EVK User Guide:
-   https://www.nxp.com/docs/en/data-sheet/MIMXRT10601064EKBHUG.pdf
+   https://www.nxp.com/webapp/Download?colCode=MIMXRT10601064EKBHUG
 
 .. _MIMXRT1064-EVK Debug Firmware:
    https://www.nxp.com/docs/en/application-note/AN13206.pdf